With five sizes available, finding the right hammer is defined by hole size and the ground drilling conditions. Just match the hammer as closely as possible to the required hole size, leaving sufficient space to allo. [pdf]
A down-the-hole drill, usually called DTH by most professionals, is basically a screwed on the bottom of a . The fast hammer action breaks hard rock into small cuttings and dust that are evacuated by a fluid (air, water or ). The DTH hammer is one of the fastest ways to drill hard rock. The system is thought to have been invented independently by Stenuic. [pdf]
Air compressor designed to take fully into account the safety of operators, but operators must ultimately be responsible for their own safety. Below the security measures only as a guidance, is aimed at the use of air compressor in the process of harm reduction. Not. .
If the air compressor within the very large space (to accommodate), in the air compressor to work outside the marked, and must cut off power and placed obvious signs. .
Work long hours in the air compressor next to the operators must wear ear protectors. .
Avoid physical and thermal fluid, heat and the exhaust pipe of contact with the surface, to avoid scalding. [pdf]
There are two types of de-dusting methods: one is wet de-dusting and the other is dry de-dusting. The two types of dust removal methods have different effects. .
The dry de-dusting system of the drilling rigmainly consists of filters and air ducts. In the process of drilling tool gouging, rock dust is blown out of the hole. .
Wet de-dusting is done by mixing the pressurized air with water through a mixer and pumping the water from the tank to the water pipe. The compressed air. [pdf]
Enter your inquiry details, We will reply you in 24 hours.
